Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Argyle, TX

Broken Garage Door Spring Repair in Argyle, TX

Fast replacement of broken torsion or extension springs, sized to your door's weight. Typical cost $200-$450.

From the first phone call to the final safety test, broken garage door spring repair in Argyle, TX follows a simple process: diagnose, quote, repair, test. Fast replacement of broken torsion or extension springs, sized to your door's weight.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for broken garage door spring repair?

  • A loud bang from the garage, like a gunshot
  • A visible gap in the coils of the spring above the door
  • The door feels extremely heavy or won't lift more than a few inches
  • The opener strains, hums or the door reverses right away
  • Cables hanging loose from the drums

Why this happens

  • Springs reaching the end of their cycle life (usually about 10,000 cycles)
  • Rust on the coils, which adds friction and stress
  • Springs that were the wrong size for the door
  • Cold weather making worn steel more brittle

Before the technician arrives

  • Don't use the opener. It can strip gears or pull the door off track.
  • Don't try to lift the door by hand. Without a working spring it may weigh 130 to 250 pounds or more.
  • Look, but don't touch: a broken torsion spring shows a clear gap in the coils.
  • Keep the door closed and keep children and pets away from it.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our broken garage door spring repair process

  1. Secure the door and safely unwind any remaining spring tension
  2. Weigh and measure the door to size the new springs correctly
  3. Install new springs (we recommend replacing both on a two-spring door)
  4. Wind, set and balance the door so it stays put halfway up
  5. Test the opener's force and auto-reverse settings

How much does broken garage door spring repair cost?

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Argyle, TX and nearby towns

Humidity in Texas puts a thin layer of rust on spring coils, and that friction wears springs out early. Coated or galvanized springs last noticeably longer here.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Besides Argyle (ZIP code 76226), we handle broken garage door spring repair in Lantana (4 mi), Northlake (4.8 mi), Double Oak (5.7 mi) and Justin (7 mi). Call (833) 435-8883 to book a visit in Argyle.

Broken Garage Door Spring Repair: frequently asked questions

How much does broken garage door spring repair cost in Argyle, TX?

Broken Garage Door Spring Repair typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do broken garage door spring repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is broken garage door spring repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Argyle requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Argyle, TX

Sommer Opener Gear & Sprocket Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$275

Genie Opener Circuit Board Replacement

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $175-$400

Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Garage Door Opener Installation

New chain, belt, screw-drive and wall-mount openers installed and programmed.

Typical $350-$800

Rolling Fire Door Inspection & Drop Testing

Annual drop testing and inspection of rolling fire doors.

Typical $150-$500

Ryobi Garage Door Opener Repair

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $125-$350

Sommer Garage Door Opener Installation

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $350-$800

Wayne Dalton Off-Track Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $175-$450

Overhead Door Torsion Spring Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $200-$450

Overhead Door Commercial Door Operator Repair

Trolley, jackshaft and hoist operators repaired and adjusted.

Typical $300-$1,200

Holmes Garage Door Garage Door Panel Replacement

Dented, cracked or rusted sections replaced or repaired to match your door.

Typical $300-$900

Wayne Dalton Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Argyle, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote